TABLE 2 - WEEKLY INSPECTION, TEST, AND MAINTENANCE REQUIREMENTS

1. CONSUMABLES:

(A) INSPECT DAY TANK FUEL LEVEL (GAS PRESSURE) AND MAIN TANK LEVEL (GAS PRESSURE) (IF APPLICABLE).
(B) INSPECT LUBRICATING OIL LEVEL.
(C) INSPECT ENGINE COOLANT LEVEL.
(D) INSPECT ENGINE, GENERATOR, FUEL TANK(S), AND COOLING SYSTEMS FOR LEAKAGE.
(E) INSPECT FOR PROPER OPERATION OF FUEL TRANSFER PUMP (IF APPLICABLE).
(F) INSPECT FUEL FILTER FOR CONTAMINATION IF FILTER IS EQUIPPED WITH A TRANSPARENT BOWL.

2. STARTER SYSTEM:

(A) INSPECT ELECTRIC STARTER FOR CLEANLINESS, MOUNTING, AND TERMINAL SECURITY.
(B) AIR STARTER:
MINIMUM 2 H SUPPLY REQUIRED (SEE CLAUSE 7.3.1).
(I) INSPECT AIR TANKS FOR PRESSURE.
(II) INSPECT VALVES FOR LEAKAGE.
(III) TEST AUXILLARY ENGINE AND COMPRESSOR FOR PROPER OPERATION.
(IV) BLEED OFF ANY CONDENSATION.

3. BATTERIES AND CHARGING EQUIPMENT:

(A) INSPECT ALL BATTERY CELLS FOR CORRECT ELECTROLYTE FILL LEVEL.
(B) TEST ALL BATTERY CELLS FOR CORRECT ELECTROLYTE SPECIFIC GRAVITY.
(C) INSPECT ELECTRICAL CONNECTIONS FOR TIGHTNESS AND EVIDENCE OF CORROSION.
(D) INSPECT BATTERY FOR CLEANLINESS AND DRYNESS BETWEEN TERMINALS.
(E) INSPECT CHARGER ELECTRICAL CONNECTIONS FOR CLEANLINESS AND TIGHTNESS.
(F) TEST CHARGER FOR PROPER OPERATION OF FLOAT AND EQUALIZE MODES.

4. ENGINE:

(A) TEST LUBRICANT AND/OR COOLANT HEATERS FOR PROPER OPERATION.
(B) INSPECT GOVERNOR CONTROL LINKAGES AND OIL LEVEL (IF APPLICABLE).
(C) INSPECT FUEL PUMP OIL SUMP (IF APPLICABLE).
(D) INSPECT FAN BELTS FOR CORRECT TENSION AND WEAR.